This PCB allows the use of MX switches and keycaps in a fightstick. Included is the PCB with JST-NH 5-pin connector soldered in place. Spacing is .75" center to center on the switches. Just solder your switches or hot swap sockets in place and you are good to go!
Wiring- I recommend the 20 pin harness from Paradise Arcade shop as that is what the board is modelled after. 20 pin harnesses from other vendors will require you to change the orientation of the directional wires. Here is a link:
Jun 7, 2020
Apr 13, 2020
Well, it somewhat worked, when I set this up with my fightstick the inputs were miss-mapped and because directional input setups are rare in fighting games, it only somewhat worked. I like to believe that other models or productions of this product work. But i do recommend testing this before shipping.
Apr 3, 2020
Purchase went smooth and PCB was expected (good quality)